PINPad
is a simple arming station that allows local control
of the security system. It is battery powered and requires
no installation tools. Many can be installed throughout
the home to provide convenient system control.
Features
• Secure 4 digit disarming
• Supports 1-button arming
• Small yet comfortable
• 5 year warranty
Enroll
by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the PINPad.
Install
using the 3M™ VHB™ tape on the back of the
PINPad to adhere it to a wall.
Operate
using the PINPad buttons. The PINPad LED will
blink when a button is activated.
Disarm
by entering the 4 digit user code on the number
pad.
Arm Away
by pressing the
AWAY
button until the
PINPad LED flashes red.
Arm Stay
by pressing the
STAY
button until the PINPad
LED flashes red.
Trigger a panic alarm
by pressing the
STAY
&
AWAY
buttons together until the red PINPad LED flashes
repeatedly.
Use the panel installation guide to verify proper system setup.
Enrollment Buttons
Arm Stay
Arm Away
LED
Mounting Screw Holes
VHB Tape
VHB Tape
RE152 PINPad
™
Interlogix
®
Compatible
IN
STALL
G
U I D E
I
Resolution Compatibles
To change the access code, do these steps:
1. Enter current 4-digit access code - the default code
is 1234.
2. Within 4 seconds, press and hold the "1" and "3"
keys simultaneously. After 3 seconds, red LED will
be lit.
3. Enter new 4-digit access code. The green LED will
be lit. Note the new code. (The access code cannot
be reset without the current access code).
Option for sending an Enrollment Signal
• Press both
STAY
and
AWAY
buttons
simultaneously
• See Pro Tips for recommendations about
using 3M VHB
tape.
• Two #4 or #6 screws may be used instead of,
or in addition to, the 3M VHB tape.
• The mounting plate can also be rotated 180
°
for table top use (See Pro Tips).
