19
Language:
English
Model:
Netti I allround
Version:
November 2010
Language:
English
Model:
Netti I allround
Version:
November 2010
Netti Rullestoler
Language:
English
Model:
Netti I allround
Version:
November 2010
Language:
English
Model:
Netti I allround
Version:
November 2010
Readjust the brakes. (See chapter
6.15).
Readjust the angle of the bearing
house. (See chapter 6.5)
6.7 Back rest
The back rest can easily be folded down by
pressing the release stay to allow to lay the
back rest down onto the seat. Ensure the
back rest click back into position when
raising it again.
The back rest angle can be changed in 3
different positions. Standard back rest angle
is 97
°
. Alternative angles are: 107
°,
97
°
&
83
°
To hange the angle of the back rest
• Loosen the screw shown in the picture
• Place the screw in the desired position
• Tighten the screw
To ensure that the screws are properly locked
in position the edge of the screw should be
parallel to the back rest hinge. See picture
6.8 Adjusting seat depth at
the rear
The seat depth can be adjusted 10 cm in the
rear and 10 cm in front.
Adjusting seat depth at the rear:
• The back rest hinge has 5 holes with 2,5 cm
distance between
• The seat depth can be adjusted from 40 - 50
cm. (Measured from front of seat plate to
back rest tube without back rest cushion)
• Pull out the locking bolt for the back rest
and place the back rest forward in the seat
•
Remove the screws holding the back rest
hinge, and set the back rest to the required
position. Do both side at the same time.
• Place the screws back and fix them.
When using the comfort seat plate, it
is recommended to change seat plate
when changing seat depth. The seat
plate comes in depth: 40 cm, 43 cm
and 46 cm.
