Once cart is fully set up with all electronic devices, it should be plugged into a medical grade outlet.
The cart should fully charge before deploying (Note: All carts are shipped with a 30% charge. If storing
in warehouse before deploying, charge fully).
While the cart is charging, the LED on the power system
user interface will flash until the battery is 100% full.
For LiFe Batteries: Allow up to 2 hours to fully charge.
For SLA Batteries: Allow up to 5 hours to fully charge.
Testing Your Cart
To test your cart for power, the unit needs to be turned on. To do so,
press and hold the power button on the power system user interface for approximately 2 seconds.
The power system will beep and the far left LED light will turn on. At this point, all powered devices
connected to the outlet strip should receive power. Once on, the LED Keyboard light may be used.
Press to turn light on/off. The LED Keyboard light has a 5 minute timeout function just in case the
light was not turned off by the operator.
Note: Monitors, laptops and other devices will need to be manually turned on.
Software Pre-Installation/Installation Note:
To download the latest software go to:
http://connectivity.powervar.com/mpm/download.asp.
Double-click the MPM View installer icon to start the install. MPM View will
automatically detect the MPM power unit attached to the PC workstation USB port.
9
ALTUS
|
3731 Northridge Dr, NW
|
Suite 1
|
Walker, MI 49544
|
T: 888.537.1311
I
www.altus-inc.com |
AS-1584_Rev.I
Charging Your Cart
Technology W
orkstation Solutions — Powered
air
