Altronix TROVE Trove2KH2, Руководство по установке

Страница: 3 / 8

Trove / Kantech Installation Guide - 3 -
TKH2: Configuration of Altronix Power Supply and/or
Sub-Assembly Boards and Kantech Boards
1. Fasten spacers (provided) to pems which match the hole pattern for Altronix Power Supply/Chargers or Altronix Sub-Assembly boards
(Fig. 2, pg. 4) .
Note: Please fasten metal spacers in the proper locations, see below (Fig. 2, pg. 4) .
2. Mount boards to spacers utilizing 3/8” pan head screws (provided) (Fig. 2a, pg. 4) .
3. Mount Altronix T1618300 transformer to backplane and connect it as follows (Fig. 2, pg. 4) :
a. Place one metal washer on the bolt, then push bolt through the square hole from the rear of backplane ( Fig. 2b, pg. 4, Step 1) .
b. Place first rubber washer on the bolt (Fig. 2b, pg. 4, Step 2) .
c. Mount T1618300 on the bolt (Fig. 2b, pg. 4, Step 2) .
d. Place second rubber washer on the bolt. Mount concave metal plate on top of the rubber washer as shown on Fig. 2b, pg. 4, Step 2 .
e. Place second metal washer on the bolt. Tighten assembly with the nut (Fig. 2b, pg. 4, Step 2) .
f. T1618300’s primary leads are black and white. Connect AC power 115VAC, 50/60Hz to them.
g. Measure output voltage across the secondary leads before connecting devices. This helps avoiding potential damage.
- Yellow and Brown for 16VAC (open circuit voltage @ 115VAC approx. 16.6VAC).
- Black and Brown for 18VAC (open circuit voltage @ 115VAC approx. 18.8VAC).
h. Connect 16VAC device(s) to Yellow and Brown leads or 18VAC device(s) to Black and Brown leads.
4. Mount appropriate Kantech boards into the correct positions (Fig. 2, pg. 4) :
a. Position spacer over appropriate hole on the rear of backplane and depress it until it locks in place (Fig. 2c, pg. 4, Step 1a) .
b. Depress down on board to secure it to the spacer (Fig. 2c, pg. 4, Step 1b) .
5. Fasten backplane to Trove2 enclosure utilizing pan head screws (provided).
Kantech Access Controller Position Chart for the Following Models:
Kantech Board Pem Mounting
KT-400 Door Controller A
KT-300 Door Controller B
KT-MOD-IN16 or KT-MOD-OUT16 Expansion Modules C