Replace with fuses rated @ 3.5A/250VA (Altronix model # Fuse1).
b. Tripped PTC (R2432300ULCB & R2432600ULCB) - To reset PTC, set power switch on back of unit to the
OFF position. After approximately 30 secs. set power switch to the ON (RESET) position (Fig. 1C, pg. 3).
10. Power switch with built-in circuit breaker:
OFF position - Switch not Illuminated. Outputs not powered.
RESET (ON) position - Switch illuminated. Outputs powered.
Circuit breaker tripped - Switch not Illuminated. Power LEDs on faceplate are not illuminated. Outputs not powered.
To reset circuit breaker set power switch to the ON (RESET) position (Fig. 1C, pg. 3).
Note: Do not exceed units electrical load ratings as indicated in reference chart ( pg. 2).
Do not place mechanical load on unit.
Unit is designed optimally for normal data room office installations. Data racks should always
be properly ventilated.
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or
moisture. This installation should be made by qualified service personnel and should conform to
all local codes and in accordance with the National Electrical Code.
AC Power
LED's
AC Power
LED's
AC Power
LED's
AC Power
LED's
AC Power
LED's
AC Power
LED's
Divider
AC Power
LED's
AC Power
LED's
Removable Terminal
Block
(Green Wire
Earth GND)
PTC1
Used
on PTC
Models
Strain Relief
Line Cord
Power Switch
RESET
XFMR*
XFMR*
P
N
N
P
Divider
S
S
P
N
N
P
S
S
P
N
S
P
N
S
28VAC
Hook Up
28
24
24
28
24VAC
Hook Up
Fig. 1
Fig. 1A
- 3 -
Fig. 1D
Fig. 1E
Fig. 1B
Fig. 1C
