E. Setting Holiday Dates:
Select chanel A or B by moving slide switch SW3 to appropiate position.
Note: Channel cannot be changed in the middle of programming events. To change channels you must exit programming then
change channel switch position then enter program mode again.
It is now necessary to assign these holiday events specific calendar dates which they are to occur.
Depress
SET
until ENTER to
SET HOL
Depress
ENTER
A01 HOL
SU 00:00
Enter the holiday date, day of week and year by depressing
UP
and
DWN
to
make the selection then depress
ENTER
to accept.
Note: Holiday events will override all regularly programmed events that occur on a particular holiday date.
F. Delete/Disable Events or Edit Events:
Select chanel A or B by moving slide switch SW3 to appropiate position.
Note: Channel cannot be changed in the middle of programming events. To change channels you must exit programming then
change channel switch position then enter program mode again.
Previously programmed regularly scheduled and/or holiday events may be deleted/disabled without having to erase all events.
Depress
SET
until ENTER to
SET EVENT
Depress
ENTER
A01 ON
TU 00:00
Now scroll using
UP
and
DWN
push buttons to the event you wish to delete, depress
ENTER
to move flashing cursor
under relay option then depress
UP
and
DWN
push buttons until DIS is displayed, depress
ENTER
to confirm.
G. Delete All Events:
This will delete all previously programmed events.
Depress
SET
until
ENTER to
CLR MEM
Depress
ENTER
CLEAR
MEMORY?
Depress
ENTER
PRESS UP
& ACCEPT
Depressing
UP
push button will now clear all events previously programmed.
If you wish to escape from this selection depress any of the other push buttons:
SET, ENTER
and
DWN
.
H. Tandem Relay Mode:
To operate in the Tandem Relay Mode, close switch SW2. This mode setting will allow events programmed for
Channel A and Channel B to operate both relays simultaneously (1 DPDT relay output). This setting doubles the amount
of programmable events.
Note: When using the Tandem Relay mode, sequential ON/Off or OFF/ON events must be programmed in the same channel.
(If there is a Channel Program conflict, such as CH A is set to ON and Channel B is set to OFF. The ON command will
override the OFF and both relays will remain ON.
>
>
appears in display.
appears in display.
appears in display.
appears in display.
will appear in display.
will appear in display.
will appear in display.
6
