PT2724
- 5 -
Depress
ENTER
until the flashing cursor appears under OFF (relay function) position in display.
Now select type of event required, by scrolling using the
UP
and
DWN
push buttons until either:
ON - Relay ON (latching mode), OFF - Relay OFF (latching mode), PL - Relay Pulse ( momentary)
appears in display. Depressing
ENTER
will make selection.
When selecting the pulse mode, PL01 will appear in the display. It is now necessary to assign the length
of time (duration of relay activation). The pulse can range in length from 1 second minimum to 15 seconds
maximum and is selected by using
UP
or
DWN
push buttons, then depressing
ENTER
to accept.
Note: If pulse duration is not selected, relay output defaults to 1 second.
Next, select individual day of the week and time (military) by scrolling using
UP
and
DWN
push buttons
and depress
ENTER
to accept. You may continue to program events by repeating the previous steps or exit
programming by depressing
SET
.
Note: When programming additional events, it is necessary to select the next consecutive event number
following the last event program to continue.
Note: When it is required to have the same event repeated on two (2) or more consecutive days of the
week (Block Programming), the event must be programmed as a block by selecting
BK
in the day field.
Note: To program the consecutive days of the week refer to Setting Block Event (weekly repeat) and
Daylight Savings Time
- section C1 below.
2. Adding Events
Depress
SET
until
appears on display.
Depress
ENTER
appears on display.
Depress
ENTER
. If the event is not programmed, the cursor will move to the OFF (relay function) position.
If the event is programmed, the cursor will move to the position and the programmed information of the event
will be displayed. At this point depress the
UP
button to step up through the programmed events. When an
unprogrammed event is reached, the cursor will move to the OFF (relay function position). At this point refer to
setting events or setting holiday events.
C. Setting Block Events (weekly repeat) and Daylight Savings Time:
Select channel A or B by moving slide switch SW3 to appropriate position.
Note:
Channel cannot be changed in the middle of programming events. To change channelsyou must exit
programming then change channel switch position then enter program mode again.
Depress
SET
until
appears on display.
Depress
ENTER
.
will appear on display.
1. Block Event Programming
Flashing cursor will appear at the location of the first day of the week desired. Depress
UP
and
DWN
to select day. Depress
ENTER
to confirm selection, then cursor will appear at the location of the last
day of the week desired. Depress
UP
and
DWN
to select day. Depress
ENTER
to confirm selection.
1) Monday through Thursday depress
MO
followed by
TH
.
2) Wednesday through Sunday depress
WE
followed
SU
.
2. Daylight Savings Programming
The cursor will appear under DS (auto clock adjust daylight savings mode) in display. To change mode
depress
UP
or
DWN
once ST (clock does not adjust standard time mode) will appear in display.
Depress
ENTER
to accept correct selection.
Note: Select
DS
for areas that observe daylight savings or
ST
for areas that don’t observe
daylight
savings.
>
A01 OFF
BK 00:00
>
ENTER to
SET EVENT
>
A01 OFF
SU 00:00
ENTER to
SET BK
A=SA/SU
TIME=DS
