- 2 -
Pace1PTM
Installation Instructions:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and
with all local codes and authorities having jurisdiction. Wiring should be UL Listed and/or
Recognized wire suitable for the application.
Pace1PTM is not intended to be connected to outside plant leads and should be installed indoors
within the protected premises. Pace1PTM is intended for indoor use only.
1. Secure unit to desired mounting surface with a proper fastening device utilizing the case’s
mounting hole (Fig. 2a, pg. 3). Unit should be mounted in the proximity of camera/device.
2. Connect structured cable from IP camera/device to RJ45 jack marked [PoE Out] (Fig. 2, pg. 3).
3. Connect Pace1PTM to the receiver (Pace1PRM, Pace4PRM, Pace8PRM or Pace16PRM):
a.
CAT5e or higher: Connect CAT5e or higher to the connector marked [RJ45 IN]
(Fig. 2, pg. 3).
UTP: For single UTP applications, jumpers (supplied) must be connected as follows:
1. Remove the four (4) screws from the Pace1PTM cover. Do not discard hardware.
2. Connect jumpers (supplied) to pins pairs [P5] and [P6] as shown (Figs. 1a & 1b, pg. 3).
3. Replace cover and secure it with the four (4) screws.
4. Connect UTP to connector marked [UTP IN].
Caution: Once PoE connection is established between the receiver and Pace1PTM, disconnection
from Pace1PTM will not disable the PoE output voltage on the receiver. Although the Pace1PTM
can be reconnected, caution should be taken not to connect the CAT5e or single UTP wiring from
the receiver to any non-PoE device.
Technical Specifications:
Parameter
Description
Connections
RJ45 for ethernet link or single pair UTP.
Input power
requirements
PoE (15W) IEEE 802.3af compliant or
PoE+ (30W) IEEE 802.3at compliant
from Pace1PRM, Pace4PRM, Pace8PRM or Pace16PRM.
Indicators
Yellow (RJ45 connector): On - Link, Off - No Link, Blinking - Activity.
Green (RJ45 connector): On - 100Base-TX, Off - 10Base-T.
Green: PoE Active.
Environmental
Conditions
Operating Ambient Temperature: UL60950-1:
For 15W: --- 40ºF to 167ºF (--- 40ºC to 75ºC).
For 25W: --- 40ºF to 158ºF (--- 40ºC to 70ºC).
For 30W: -- 40ºF to 140ºF (--- 40ºC to 60ºC).
Relative humidity: 20 to 85%, non-condensing.
Storage Temperature: -- 40ºF to 167ºF (--- 40ºC to 75ºC).
Operating Altitude: -- 1000 to 6,561.679 ft. (-- 304.8 to 2000m).
Regulatory
Compliance
UL/CUL Listed for Information Technology Equipment (UL 60950-1).
Weights (approx.) Product: 3.88 oz. (0.11 kg.), Shipping: 6.70 oz. (0.19 kg.)
