Mounting Options:
Rack Mount Installation
1- Remove and discard factory installed screws from both sides of rack chassis (Fig. 3a).
2- Install mounting brackets (A) on the left and right side of rack chassis using the four (4) flat head screws (B) (included) (Fig. 3b).
3- Place unit into desired EIA 19” rack position and secure with mounting screws (not included) (Fig. 3c).
Fig. 5
C
Left Side
Rubber Pad
B
A
C
Mounting Hardware
(Included)
:
Two (2) mounting brackets
Six (6) flat head screws
for mounting brackets.
Four (4) rubber pads.
A
B
Fig. 3b
Fig. 3a
Fig. 3c
Top
Top
Top
Front
Left
Front
Left
Front Left
Remove
B
A
Fig. 4
Fig. 4b
Fig. 4a
Dotted lines indicate studs
behind sheetrock.
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New York 11220 USA | phone: 718-567-8181 | fax: 718-567-9056
website: www.altronix.com | e-mail: [email protected] | Lifetime Warranty | Made in U.S.A.
IINetWaySP2/4/8 K29Q
MEMBER
The lightning flash with arrowhead symbol within an equilateral triangle
is intended to alert the user to the presence of an insulated DANGEROUS
VOLTAGE within the product’s enclosure that may be of sufficient magnitude
to constitute an electric shock.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
CAUTION: To reduce the risk of electric
shock do not open enclosure. There are no
user serviceable parts inside. Refer servicing
to qualified service personnel.
Wall Mount Installation
1- Install mounting brackets (A) on the left and right side of rack chassis using
four (4) flat head screws (B) (included) (Fig. 4a).
2- Place unit at desired location and secure with #6 size screws or larger (not included) (Fig. 4b).
Caution: It is necessary to make sure mounting screws are securely fastened
to a beam when installing the unit vertically.
Shelf Installation
1- Position and affix rubber pads (C) (included) at each
corner on the bottom of the unit (Fig. 5).
2- Place unit in desired location.
