AL400ULX series
- 3 -
Power
Distribution
Module(s)
+
DC ---
NC C NO NC C NO
+
BAT ---
AC
DC
Bat
Risk of Fir
e,
Replace Fuses
As Marked
AC Fail
Bat Fail
J1
SW1
5A 250V
15A 250V
AC Delay
15
L
G
N
Door
CAUTION: De-energize unit prior to servicing. For continued protection against risk
of electric shock and fire hazard replace fuse with the same type and rating.
Do not expose to rain or moisture.
Green
Lead
Battery connection (non power limited)
Switch Position:
24VDC = SW1 OFF
12VDC = SW1 ON
Wire
Strap
(from
Enclosure
to Door)
115VAC
power mains
non-power
limited
Battery & AC
Supervision
Circuit
(power limited)
Class 1
-
Divider
power limited
For 12VDC Operation
use hook-up in the
inset on the right
CAUTION: When power supply board is set for 12VDC use only one (1) 12VDC
stand-by battery.
Keep power limited wiring separate from non-power limited. Use minimum 0.25" spacing.
12VDC Rechargeable Battery
(optional)
12VDC Rechargeable Battery
(optional)
SW1
Battery & AC Supervision
Circuit
(power-limited)
NC C NO NC C NO AC Fail
Bat Fail
J1
AC Delay
OFF - 24V
ON - 12V
ON
1
OFF - 24V
ON - 12
V
ON
1
Stand-by Specifications
(total current shown)
:
Output
4 hr. of Stand-by and
5 Minutes of Alarm
24 hr. of Stand-by and
5 Minutes of Alarm
60 hr. of Stand-by and
5 Minutes of Alarm
12VDC / 40AH Battery
Stand-by = 4.0A
Alarm = 4.0A
Stand-by = 1.0A
Alarm = 4.0A
Stand-by = 300mA
Alarm = 4.0A
24VDC / 12AH Battery
--------
Stand-by = 200mA
Alarm = 3.0A
--------
24VDC / 40AH Battery
Stand-by = 3.0A
Alarm = 3.0A
Stand-by = 1.0A
Alarm = 3.0A
Stand-by = 300mA
Alarm = 3.0A
Installation Instructions:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/NFPA 72/ANSI, and with all local
codes and authorities having jurisdiction. Product is intended for indoor use only.
1. Mount unit in the desired location. Mark and predrill holes in the wall to line up with the top two keyholes in the
enclosure. Install two upper fasteners and screws in the wall with the screw heads protruding. Place the enclosure’s
upper keyholes over the two upper screws; level and secure. Mark the position of the lower two holes. Remove the
enclosure. Drill the lower holes and install two fasteners. Place the enclosure’s upper keyholes over the two
upper screws. Install the two lower screws and make sure to tighten all screws (Enclosure Dimensions, pg. 7-8).
Fig. 1
Fig. 1a
Fig. 1b
Fig. 1c
