O p e r a t i o n a l M a n u a l
ALTOX GSM-4 GPS
General Guide for Installation
-
Install the device as far as possible from metal parts and wiring
harnesses
.
-
For better receiving of GPS-GLONASS signals direct the upper part of the
device casing to the windshield minding metal obstacles.
- Recommendation: c
onnect device supply directly to the OBD-II connector
wires where pin 16 is +12В, pin 4 is GND (common)
.
-
Analog output AN commutates at GND. It is used to start some heaters
using an analogous signal and to connect status LED located in the button
from the package
.
-
Auxiliary output OUT commutates at GND. It is used to connect a coolant
pump or the interior's heater via a power relay. It is switched on with the
delay (see SMS-command TIME2) after the heater is switched on. It is
switched off with the delay (see SMS-command TIME3) after the heater is
switched off.
-
If you need to implement additional options of remote control of output
OUT (for example, to block engine remotely) activate setting SEPAROUT1.
It switches the output mode into manual control mode
(
SMS-commands:
ACTIVATE / DEACTIVATE)
.
In this mode setting KEEPOUT1 activates option to save and to
subsequently restore of output OUT state when the module's power supply
is switched off and then switched on, respectively.
Please indicate the place of ALTOX module's location in the vehicle for
possible maintenance
:
Authorized Service
:
Installation Date:
Altox
