Altos P10 F6, Руководство пользователя

Страница: 29 / 35

25
System troubleshooting
Resetting the system
Before going through in-depth troubleshooting, attempt first to reset
the system using one of the methods below.
Perform Purpose To do this
Soft boot To clear the system memory and reload the Press < Ctrl > +
reset operating system. < Alt > + < Del >
Cold boot To clear the system memory, restart POST, Turn the system off
reset and reload the operating system. This will and then on again.
halt power to all peripherals.
Initial system startup problems
Problems that occur at initial system startup are usually caused by an
incorrect installation or configuration. Hardware failure is a less possible
cause. If the problem you are experiencing is with a specific application,
see the
“There
is problem with the software
program”
section on
page 29 .
Initial troubleshooting checklist
Use the checklist below to eliminate possible causes for the problem
you are encountering.
•
AC power is available at the wall outlet?
•
Is the power supply module properly installed?
•
Is the system power cord properly plugged into the power
supply module socket? and connected to a NEMA 5-15R outlet
for 100-120 V or a NEMA 6-15R outlet for 200-240 V?
•
Are all peripheral cables correctly connected and secured?
•
Did you press the system power button to turn the workstation
on (power on indicator should be lit green)?
•
Are all device drivers properly installed?
•
Are hard disk drive(s) properly formatted and configured?