9097421000(1)2008-01 A
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
17
USER MANUAL
ENGLISH
TANK EMPTYING
An automatic float shut-off system (54) turns off the vacuum system when the recovery water tank (60) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the floor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the float is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the switch (36), then
open the cover (22) and check that the float inside the grid (55) has gone down to the water level. Then close
the cover (22) and turn on the vacuum system by pressing the switch (36).
When the recovery water tank (60) is full, empty it according to the following procedure.
Recovery water tank emptying
Stop the machine by releasing the pedal (3).
Lift the brush/pad-holder deck and the squeegee by pressing the pedal (34).
Drive the machine to the appointed disposal area.
Empty the recovery water tank with the hose (10). Then, rinse the tank with clean water.
Solution tank emptying
Perform steps 1 to 3.
Empty the solution tank with the tap (24). Then, rinse the tank with clean water.
AFTER MACHINE USE
After working, before leaving the machine:
Remove the brushes/pad-holders as shown in the relevant paragraph.
Empty the tanks (60 and 61) according to the procedure shown in the previous paragraph.
Perform the daily maintenance procedures (see the Maintenance chapter).
Store the machine in a clean and dry place, with the brushes/pad-holders and the squeegee lifted or removed.
PUSHING/TOWING THE MACHINE
To push/tow the machine easily when the drive system cannot be used, unlock the electromagnetic brake (27) by tightening the
screws (29) completely (turn them clockwise) with the supplied key.
When pushing/towing procedure is over, loosen the screws (29) for 3 turns approximately, to lock the electromagnetic brake (27).
WARNING!
If the screws (29) are not loosened as shown, the electromagnetic brake is deactivated.
WARNING!
Do not start the machine when the electromagnetic brake unlocking screws (29) are tightened (electromag-
netic brake deactivated).
It is safer to tighten the screws (29) only for the time necessary to move the machine by hand.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Machine Use paragraph.
Before disconnecting the battery red connector (74) perform the following procedures:
Open the covers (51 and 58) and check that the tanks (60 and 61) are empty, otherwise empty them through the drain
hose (10) and the tap (24).
Close the covers (51 and 58).
Carefully lift the tank assembly (71).
FIRST PERIOD OF USE
After the first 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
1.
2.
3.
•
•
•
Содержание SCRUBTEC R 361
Страница 108: ......
