6
Now you can turn on the power switch.
Turn up the volume control, use the PFL function to get the proper input level for each mixer channel, then adjust
the main mix level control to manage the output level.
Make sure that the mixer has been connected to the system by using the appropriate connector and the
customized cable, as shown in Fig.7.
Connect Microphone, CD, Tape or MD player (Line sources) etc. to the appropriate MIC/LINE mixer
input connectors (XLRor1/4"TRS jacks), as shown in Fig.8.
Connect one side of the speaker cable to the left/right power outputs (speakon connectors) of system, and
the other side to the left/right speaker cabinets (speakon connectors), as shown in Fig.6.
Warning! Do not connect additional speakers to the powered output. The supplied system speakers provide
a perfect load for the built-in amplifier.
After that, set up the system.
Note: During this step too the system must be powered off, and , in order to avoid damaging your speakers and/or to
produce noise the mixer main volume control should be competently turned off.
Fig.7
Fig.6
Fig.8