6
4. GETTING STARTED
4.1 Configuration of The System
Meanwhile, the system will restore the exact operating conditions at the time of switching off.
At first, switch off the equipment, carry out the audio and power connection from the various components of your
sound system.
Then, connect the main cord and only switch on the MAXIDRIVE2.3+. The display will show the data regarding
with the operating system release for a few seconds.
M A X
D R I V E
2 . 3
R e l e a s e
1 . 0
-
-
I
The powerful versatile signal processor MAXIDRIVE2.3+ is mainly designed for use with audio systems. Its routing
configurations of the input and output can be only set by recalling one of the PRESETS included in the internal memory.
So the user must be very clear about the main function of the unit in order to get a best operation of your MAXIDRIVE2.3+.
Before you start your operation, please read the following parts carefully:
+
And the system Will enter into default status, showing the main operating information on the display.
A 1 3
B 2 4
2
F
2 x 2 W
Load the
containing the
you've found.
Factory PRESET
configuration
Press the
Key until the
menu LED lights up.
MODE
PRESET
The display will show the
page:
Load PRESET
Set all the MAXIDRIVE2.3+ outputs in MUTE status (LEDs lit) by pressing the relative keys.
the PRESETS
Use the
to find the necessary Factory PRESET (indicated by the letter ). Check that if, among
DIAL
F
available, there are already some optimised for the specific speaker enclosures being used.
Press
.
ENTER
The display shows the PRESET loaded in the units memory and the relative configuration:
(example)
(example)
L o a d
5
F
4 W + B S U B
P r e s e t
A 1 2
B 4
3
5
F
4 W + B S U B
It is much more important to set the input signal of a digital unit than that of
excessively
an analog unit, because
high input signals will make
particularly distinct noise (high
any saturation of the A/D converters cause a typical
level square wave).
4.2 Adjusting The Input Signal
