5
7.ENTER Key
The key allows you to access to the selected editing
. P
ou can edit and confirm
value of parameter.
page
ressing this key, y
the required
9.INPUT LEVEL LED Meters
The LEDs are used to indicate the level of input A/B. In order to get an up-front distortion-free signal, you keep
the signal quite high, but do assure that the red CLIP LED doesn't light up continually.
10.MUTE Switches
There are four mute switches (1-4). They are used to mute the signal of the respective outputs. When the switch
is on, the corresponding LED will light up. These switches can avoid signal peaks when switching on and off the
sound system and isolate the individual audio sections during testing or checking sound, etc.. The restored Mute
function can be set to use the Wake Up Function (Utility menu Misc. Setup submenu) and can be set as Normal
(last setting before the unit was switched off) or Mute (all outputs automatically forced into Mute status).
3.2 The Rear Panel
14
12
15
13
8.ESC Key
11.OUTPUT LEVEL LED Meters
These LEDs indicate the level of the respective outputs (you can adjust the output via adjusting the Output Gain
parameter of Edit menu.)
Note: The LIMITER on any output will change the way in which the level is displayed on the corresponding LED.
In fact, the level shown on the ladder is no longer the "absolute" output level, but the level of the signal at -24dB,
-12dB, -6dB compared to the limiter threshold (indicated by the orange LIMIT LED).
12.AC Inlet and Fuse Holder
13.Power Switch
The switch is used to turn the main POWER on and off. Note: before turning on the unit, please make sure the
amplifiers of the sound system are off to avoid the annoying and sometimes dangerous signal peaks.
CAUTION:
If there is something wrong with the fuse or the fuse needs to change, please refer to a qualified
technician. If the fuse continues to blow after replacing, discontinue using of this unit before being repaired.
PWR
OFF
ON
AC INPUT
14W
95-240V
50/60Hz
FUSE: 95-120V T500mAL
210-240V T315mAL
INPUT A
INPUT B
4
3
2
1
OUTPUTS
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
A102
PUSH
1
3
2
NEW
TIDE
PUSH
1
3
2
NEW
TIDE
Use it to connect your MAXIDRIVE2.3+ to the supplied AC cord. Please check the Voltage in your country and
what voltage for your MAXIDRIVE2.3+ is configured before attempting to connect the unit for the main AC.
The fuse can protect the AC supplies circuit of the equipment.
14.OUTPUTS
These (Outputs1~4) are balanced XLR-M connectors. A/D conversion is executed by high quality, low noise,
20 bit converters.
15.INPUTS
INPUT A and INPUT B are compatible with balanced XLR and JACK. They are audio connectors of the respective
sections. A/D conversion is executed by high quality, low noise, 20 bit converters.
The key allows you to exit the selected editing page. It can be also used to reject the value to return to the stored
value.
