6
3. CONTROL ELEMENTS
5. INSTALLATION AND CONNECTION
5.1 Mains Connection
Please ensure that the
is set to the correct supply voltage before plugging
the power cord into the wall outlet, use the same fuse as marked on the fuse
holder at the AC power connection. The mains connection of the
is made
by using the enclosed mains cord and a standard IEC receptacle. It meets all of
the international safety certification requirements.
LTO Q
LTO Q
5.2 Audio Connection
The
presents with balanced XLR & 1/4" TRS
It can be
interfaced in several ways to support a variety of applications without any
signal loss. The
can be used on a single instrument by connecting to the
mixing console's main inserts, or on an entire mix "in-line" between a mixing console's
outputs and a power amplifier. The defective wiring may degrade the performance
of
, so please use good quality screened audio cables only. Please follow
the guide below to interface
without experiencing any noise or signal
loss.
LTO Q
connectors.
LTO Q
LTO Q
LTO Q
Ok, you have got to this point and you are now in the position to operate your
successfully. However, we advise you to read carefully the following
section to be the real master of your own mix. Not paying attention enough to
the input signal level, to the routing of the signal and the assignment of the
signal will result in unwanted distortion, a corrupted signal or no sound at all.
So you should follow this procedure for every single channel:
LTO Q
Strain Clamp
Sleeve
Tip
Ring
Sleeve=Ground/Screen
Ring=Right Signal
Tip=Left Signal
Use for Headphone
1/4" Stereo (TRS) Jack Plug
Strain Clamp
Sleeve
Tip
Sleeve=Ground/Screen
Tip=Signal
Use for Mono Line In, Mono 1/4" Jack Plugs
1/4" Mono (TS) Jack Plug
