3. CONTROL ELEMENTS
SPO
TLIGHT
3. CONTROL ELEMENTS
If you engage in this button, the LED Meter will read the output level, and
release this button, the LED Meter will read the input level.
10 INPUT/OUTPUT Meter Button
The readable range of this 12 segments LED display is -30 dB to +18 dB. As
mentioned before it will read either the INPUT or the OUTPUT level depending
on the position of the switch (10).
11 INPUT/OUTPUT Level (LED Meter)
Rear Panel
3
8 HIGH CUT Control
When activate this control, it will cut the high frequencies with a slope of
12 dB per octave in a range of 2.5 kHz to 30 kHz. So if you set this control
at the maximum position of 30 kHz, the audio signal will pass through
without alteration.
You can control the amount of the audio signal fed into your
LTO Q via this
control. The adjustable range goes from -15 dB to +15 dB.
9 INPUT Control
13 Output Connectors
The unit
Balanced XLR and 1/4" TRS jack output sockets which wired
in parallel. The Balanced signals are less sensitive to hum generated by AC.
features
14 Input Connectors
It also features Balanced XLR and 1/4" TRS jack input sockets which wired in
parallel. The Balanced signals are less sensitive to hum generated by AC.
Standard IEC receptacle. Connect your
to the AC with the supplied
AC power cord. Before powering up your
for the first time, make
certain the stated power requirement of the unit matches the voltage supplied
by the AC socket.
LTO Q
LTO Q
If the fuse blows, replaced with a fuse of the correct type only.
12 AC Inlet and Fuse holder
OUTPUT
INPUT
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
A101
Rated Power Consumption 9W
FUSE:
210-240V: T200mAL 250VAC
95-120V: T315mA 250VAC
REPLACE FUSE WITH CORRECT TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
DESIGNED IN ITALY
MADE IN CHINA
12
13
14
