Alto-Shaam AR-7H ELECTRONIC CONTROL, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 32

MN-28953 (Rev 0) • 09/13 • AR-7H Hot Holding Rotisserie Companion Operation & Care Manual • 7
I N S T A L L A T I O N
S T A C K I N G I N S T R U C T I O N S
The holding cabinet can be stacked with an
identical holding cabinet or a matching rotisserie
oven in either the top or bottom position.
Only screws, lock washers, and hex nut are
required to fasten units together when stacking
a rotisserie on top of a matching holding cabinet
or a holding cabinet on top of a holding cabinet.
Additional stacking hardware is required for all
other combinations (
see previous page
).
All fastening holes have been prepunched. If
the rotisserie oven is positioned at the bottom of a
stacked configuration, make certain the oven is on a
non-combustible surface. The stacking combination
also requires the minimum clearance of
6" (152mm)
at
the back and both sides.
1
Remove the two side access panels of both units.
2
Carefully lift and place the upper unit into
position aligning on bottom unit.
3
Secure units together by inserting a hex head
screw, a flat washer, and a lock washer in each
hole of the top unit and screwing them into the
inserts provided on the top of the lower unit.
Securely tighten all four screws.
4
Replace the side panels on both units.
A
2
3
3
4
1
A
2
3
3
4
1
AR-7H
oveR
AR-7H
Holding cAbinet stAcking Assembly
(5009711)
item
no
.
pARt
no
.
pARt descRiption qty
1 NU-2437 NUT, 1/4-20 HEX S/S 4
2 SC-27385 SCREW, 1/4-20 X 3/4" LG HEX HEAD 4
3 WS-22094 WASHER, 1/4", FLAT, 5/8 OD 18-8 SS 8
4 WS-2294 WASHER 1/4" SPLIT 4