Alto-Shaam AR-7H ELECTRONIC CONTROL, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 32

S E R V I C E
MN-28953 (Rev 0) • 09/13 • AR-7H Hot Holding Rotisserie Companion Operation & Care Manual • 16
D A N G E R
LOCK-OUT OR POST
BREAKER PANEL UNTIL
SERVICE WORK HAS
BEEN COMPLETED.
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
D A N G E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.
CABLE HEATING SERVICE KIT NO
. 4876
INCLUDES
:
CB-3044
CABLE HEATING ELEMENT
...................................210
FEET
CR-3226
RING CONNECTOR
....................................................... 8
IN-3488
INSULATION CORNER
.............................................8
FEET
BU-3105
SHOULDER BUSHING
.................................................... 8
BU-3106
CUP BUSHING
............................................................. 8
SL-3063
INSULATING SLEEVE
..................................................... 8
TA-3540
HIGH TEMPERATURE TAPE
.....................................1
ROLL
ST-2439
STUD
, 10/32 ............................................................. 8
NU-2215
HEX N UT
.................................................................. 16
CABLE REPLACEMENT KIT
T R O U B L E S H O O T I N G G U I D E - M A N U A L C O N T R O L
TROUBLE POSSIBLE CAUSE REMEDY
Unit does not operate. Insufficient power supply
Defective power cord or plug
Defective power switch.
Defective thermostat. Check power source.
Check and replace if necessary.
Check and replace if necessary.
Replace thermostat and calibrate.
Cannot control temperature. Defective thermostat.
Grounded element. Replace thermostat and calibrate.
Replace element (check element to
ground Ohm element @ 27.7 Ohms).
Temperature gauge readout incorrect. Defective temperature gauge
Calibration off.
Replace temperature gauge.
Calibrate according to instructions
found on page 9.