Altis ICONA, Руководство пользователя

Страница: 14 / 22

13
1. Probable reason for computer not workable after power start: The wire from computer to bottom control
board didn’t connected well or the transformer was burnt out. Check the each wire from computer to
control board, make sure they are connected well. If the wire is destroyed , change it. If the above can not
settle the problem, try to change a good transformer.
2. Display E01: Message failure. Probable reason: The wires from computer and bottom control board didn’t
connect well, please check each wire. If the wire was destroyed, change a good one.
3. Display E02: Burst clash. Check the power is right, if not, use correct power to test; Check if the bottom
control was burnt out, change a good one; reconnect the motor wire.Check the motor,or change a good
one
4. Display E05 overcurrent protection. the reason is overloading of power, starting the system
self-protection, or the parts of machine being stocked, result to motor power off; re-setting the panel and
press “START”. Inspecting whether the smell of burning of motor or the sound of voltage , exchange the
motor, or the controller; checking the power voltage whether normal or not , testing the voltage with usual
value.
5. If the motor can not work after pressing START button, the probable reason: the motor wire is broken;
the safety pipe is broken or fell; motor wire is not connected well; IGBT on bottom control board is burnt
out. Test the above reasons and change the relevant part.
EXERCISE INSTRUCTIONS
WARM UP STAGE
If you are over 35 years old, or not very healthy, also it’s your first time exercise, please consult with
your doctor or professional person.
Before you use the motorized treadmill, please learn how to control the machine, know well how to
start, stop, adjust the speed and so on, don’t stand on the machine at this time. After that, you can use the
machine. Stand on anti-slip pad both sides and handle the handle bar with your both hands. Keep the
machine at the low speed about 1.6~3.2 km/h, then test the running machine by one foot, after get used to
the speed, then you can run on the machine and you can add the speed between 3 and 5 km/h. Keep the
speed about 10 minutes, then stop the machine.
EXERCISE STAGE
Learn how to adjust the speed and incline before using. Walk about 1 km at stable velocity and write
down the time, it will take you about 15-25 minutes. If walk at 4.8 km/h, it will take you about 12 minutes in
1 km. If you feel comfortable at the stable velocity, you can add the speed and incline, after 30 minutes, you
can have good exercise. At this stage, you can not add the speed or incline too much at one time, it can
keep you feel comfortable.