UNDER TABLE 4X1 HDMI SWITCHER
User’s Guide
400-0616-001
1
Welcome!
Everyone at Altinex greatly appreciates your purchase of the
UT260-041. We are confident that you will find it to be reliable
and easy to use. If you need support, please do not hesitate to
call us at 714-990-2300.
At Altinex, we are committed to developing unique and state of
the art Signal Management Solutions
®
for demanding audiovisual
installations. Welcome to the Altinex family of satisfied customers
around the world!
1. Precautions and Safety Warnings
These instructions are to ensure the reliable operation of
your UT260-041 and to prevent fire and shock hazards.
Please read them carefully and heed all warnings.
1.1 General
Qualified ALTINEX service personnel or their authorized
representatives must perform all service.
1.2 Installation Precautions
To prevent fire or shock, do not expose this unit to water or
moisture. Do not place the UT260-041 in direct sunlight, near
heaters or heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can harm
internal components.
Handle carefully; dropping or jarring can cause damage.
Do not pull any cables that are attached to the UT260-041.
1.3 Cleaning
Clean with a dry cloth only. Never use strong
detergents or solvents such as alcohol or thinner.
1.4 FCC Notice
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 2 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions found herein, may cause harmful interference to
radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at their own expense.
Any changes or modifications to the unit not expressly
approved by ALTINEX, In
c. could void the user’s authority to
operate the equipment.
2. Installation Procedures
Note:
Download and read the entire online manual to become familiar with the
UT260-041 and for detailed information.
Step 1: The enclosure mounts under the table using Velcro. The compact and
lightweight design requires only Velcro to secure the unit in place.
Step 2: Connect HDMI
®
Input cables from the sources including all ShareTime
collaborative controllers and/or retractor units.
Step 3. Connect the digital output directly to the HDTV.
Step 4. Apply power to the unit. Power can be applied through the USB port or the DC port; power adapter included.
Step 5. ShareTime units that are included with the UT100-041 are
preconfigured; configure other controllers as described below.
Step 6. The UT260-041 is ready for use. Connect a ShareTime
controller to a source and wait for the green LED; this is the
active source. Press the touch sensor when green to de-select
and display the ShareTime standby screen. Press again to re-select and become the active source. Connect another
ShareTime controller to an HDMI source and it will take over control.
ShareTime Configuration (ST100-001, RT300-101, and CB300-101)
Download the online manual for individual ShareTime units for details on operation and configuration.
ShareTime units purchased separately must be connected to the switcher and an HDMI source then configured as follows:
Enable de-select: Press & hold the CONFIG button until the LED turns RED. Release and wait for ShareTime restart.
Disable detection: Press & hold the TOUCH sensor until the LED turns YELLOW. Release and wait for ShareTime restart.
