CNK200 Interconnect Box
User’s Guide
400-0111-009
13
7. Operation
7.1 Accessing the CNK200
The CNK200 cover opens easily and remains open until all the
cables are connected. The cover should be closed with the
cables routed through the curved opening to prevent damage
to the unit and to prevent liquids from entering the opening.
Additionally, the cover should be closed when not in use to
prevent liquids or other debris from damaging the unit.
7.2 Power/Signal Connections
Connect external devices to the appropriate connector from the
CNK200. Remember, the devices plugged into the AC power
connectors should not draw more than the rated values of the
cables and/or circuit.
8. Troubleshooting Guide
The CNK200 supplied was carefully tested and no problems were detected. However, we would like to offer the following suggestions:
CNK200 Series
Symptom
Resolution
No Display
1. Check the source and make sure there is a signal present.
2. Make sure the monitor has power and is turned on.
Poor Output Image
1. The source resolution may not be compatible with the projector or other display device. Try
other resolutions from the source.
2. The source and display may not be compatible. Connect the source directly to the input of the
projector or other display device. If the image is poor the devices may be incompatible.
Don’t know the IP
address
1. Please make sure that the highest quality network cables are used.
2. Make sure that no cable or power cord is damaged or pinched. If there has been damage, do
not use the CNK200. Please call the Altinex Customer Service Department at (714) 990-2300 to
have the unit repaired.
System Failure
Please call the Altinex Customer Service Department at (714) 990-2300 to have the unit repaired.
