Altigen MAX1000, Руководство пользователя

Страница: 54 / 68

MAX2000 System
50
Telephony Hardware Manual
Additional Hardware
The MAX1000-R hardware differs from MAX1000 hardware in the following ways:
•
Supports two ALTI-M0404-T1E1 spans, instead of one
Note: When you are using two T1 or E1 spans, and one is used as a back-to-back
tie trunk and the other is a live CO line, the live T1 or E1 line must connect
to the top slot.
Note: When no T1/E1 or one T1/E1 board is installed, you can select:
•
30 G.723/G.729/G.711 IP channels, OR
•
12 G.723/G.729/G.711 IP channels plus 48 G.711-only IP channels
When two T1/E1 boards are installed, the configuration will switch to 12
G.723/G.729/G.711 IP channels and 48 G.711-only IP channels
automatically.
•
SATA RAID controller
•
Supports SATA RAID1 with 80GB hard disk
•
1GB RAM
System Limitation for MAX1000-R
•
Trunk recording is not supported. Only extension recording is supported.
MAX2000 System
The MAX2000 system uses the same DSP board and supports all the same analog and
digital access boards as the MAX1000 and MAX1000-R.
The MAX2000 hardware differs from the MAX1000 hardware in the following ways:
•
Hot swappable power supply (2x250W)
•
Hot swappable RAID1 with 2x80GB hard disk
•
Pentium Processor
•
1GB RAM
•
Supports two ALTI-M0404-T1E1 spans, instead of one
The MAX2000 system is manufactured with two different DSP configurations, MAX2000
standalone server and MAX2000iG:
•
MAX2000 Server —In standalone server mode, the MAX2000 Server supports the
same software features and uses the same firmware as the MAX1000-R.
When
no T1/E1 or one T1/E1 board is installed, you can select:
•
30 G.723/G.729/G.711 IP channels, OR
•
12 G.723/G.729/G.711 IP channels plus 48 G.711-only IP channels
When two T1/E1 boards are installed, the configuration will switch to:
•
12 G.723/G.729/G.711 IP channels and 48 G.711-only IP channels
Note: In the event that the installation site grows beyond the supported user size
and you would like to migrate to HMCP Softswitch architecture, the MAX2000
standalone server can be configured in gateway mode. The embedded DSP
will be changed to support the codec listed in MAX2000iG.