Altherma EKHBHE008AA3V3, Руководство по эксплуатации

Страница: 10 / 20

Operation manual
9
EKHBH/XE008AA3V3
Indoor unit for air to water heat pump system and options
4PW48442-1B
Programming quiet mode, booster heating or domestic water
heating
Programming domestic water heating, booster heater or quiet mode
is carried out as follows:
1 Press the < button.
The actual mode is blinking.
2 Use the
pi
and
pj
buttons to select the mode you want
to program (quiet mode s , booster heating m or domestic
water heating w ).
The selected mode is blinking.
3 Press the < button to confirm the selected mode.
The first programmed action is displayed.
4 Use the
pi
and
pj
buttons to consult the programmed
actions.
This is called the readout mode. Empty program actions (e.g. 4
and 5) are not displayed.
5 Press the < button for 5 seconds to enter the programming
mode.
6 Use the < button to select the action number you would like to
program or to modify.
7 Use the pi and pj buttons to set the correct action time.
8 Use the ba button to select or deselect x as action.
9 Repeat steps 6 to 8 to program the other actions of the selected
mode.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
10 Press the < button for 5 seconds to store the programmed
actions.
If the < button is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored but 4 and 5 are deleted.
You automatically return to step
4 . By pressing the
pr
button
several times, you return to previous steps in this procedure and
finally return to normal operation.
Consulting programmed actions
Consulting space cooling or space heating actions
Consulting space cooling or space heating is carried out as follows.
1 Use the
=
button to select the operation mode (cooling or
heating) you want to consult.
2 Press the
<
button.
The actual mode is blinking.
3 Press the < button to confirm the selected mode.
The actual day is blinking.
4 Select the day you would like to consult by means of the
pi
and
pj
buttons.
The selected day is blinking.
5 Press the < button to confirm the selected day.
The first programmed action of the selected day appears.
6 Use the
pi
and
pj
buttons to consult the other
programmed actions of that day.
This is called the readout mode. Empty program actions (e.g. 4
and 5) are not displayed.
By pressing the
pr
button several times, you return to previous
steps in this procedure and finally return to normal operation.
NOTE Returning to previous steps in the programming
procedure without saving modified settings is done by
pressing the
pr
button.
Simultaneous operation of compressor, backup heater and
booster heater is NOT possible.
The domestic water heating schedule timer must
completely overlap the booster heater schedule timer. The
booster heater can not work if the domestic water heating
schedule timer is not active.
Refer to the separate addendum for an example of
schedule timer programming.
Before you start any programming, read attentively the
warnings mentioned in the paragraph
"Introduction" on
page 2 to understand unit operation and how to program
schedule timers.
NOTE
Consulting space cooling or space heating is done in
the same way. At the start of the consulting procedure
space cooling or space heating is selected. After that,
you have to return to the start of the consulting
procedure to consult the other operation mode.
NOTE
Returning to previous steps in this procedure is done
by pressing the
pr
button.