Product Instructions - General
INTENDED USE
ELECTRICAL CONNECTION AND ADJUSTMENT
MECHANICAL INSTALLATION
PR3850 SERIES
DISCLAIMER
Althen
operates a policy of continuous improvement
and product development. We reserve the right to
change specification and operating instructions
without prior notice.
Please observe applicable safety regulations when installing
or removing pressure transmitter.
Please refer to datasheet, calibration certificate
and read installation instructions before starting
installation
The device must be used within the specified
pressure, temperature and supply voltage
range.
INSTALLATION
During installation please comply with the
relevant national guidelines
Installer must be technically competant and
familiar with pressure monitoring technology
Ensure electrical connector and cable gland are
securely fitted and sealed
MAINTENANCE
Recalibration interval depends on own industry
guidelines
Do not insert pointed or hard objects in to the
pressure port
Repairs must be performed by manufacturer
only
REMOVAL/ END OF LIFE
Ensure system is depressurised before removal
Remaining media in pressure port may be
hazardous
Ensure system is not pressurised before
installation
Ensure that the measurement cell is not
damaged during installation
Use either a correct sized AF wrench on the
hexagon with tightening torque in accordance
with the table. The customer must ensure that
the pressure seal is suitable for application
WEEE can be returned to factory at end of life
for recycling
Tightening torque setting guideline in table
overleaf
ELECTRICAL INSTALLATION
Make mechanical installations first so as not to
twist the cable
Refer to product calibration certificate for wiring
diagram
8
Protran® PR3850
User Manual
