Alternate Heating COAL GUN S1000, Инструкция по установке и эксплуатации

Страница: 53 / 64

45
Dwyer 16C-2 Programming
INITIAL PROGRAMMING
1. Selecting Input Type
A. Hold button for three seconds, until you see:
B. Scroll with or until you see input type:
C. Press
2. Setting Temperature Unit
A. Hold button for three seconds, until you see:
B. Press repeatedly until you see
C. Scroll with or until Fahrenheit is selected
D. Press twice
3. Setting Control Method
A. Hold button for three seconds, until you see:
B. Press repeatedly until you see
C. Use or until the readout shows
D. Press twice.
4. Setting Temperature offset for Grate Control (Heating Hysteresis)
A. Press , the top LED readout will display
B. Use the or to set the bottom readout to a value of 10
C. Press twice
5. Set Grate Operation Temperature
Use and to select temperature. When the desired temperature setting is shown in the bottom
readout, press . The grate operating temperature is set at the factory to 140° F. When the ash
temperature drops to 10° (or whatever offset value is entered in step 4.) below the set value the grate
system will remove ash. A.H.S. strongly recommends not setting the S.V. temp below 120° F and not
above 150°F.
LOCKING CONTROL
Press twice, LOC will be displayed, press to set bottom readout to 1 , Press
UNLOCKING CONTROLS Press and at the same time (until display blinks). Then set the
operation temperature, as in step 5. (Set Grate Operation Temperature) above.