Alternate Heating COAL GUN S1000, Инструкция по установке и эксплуатации

Страница: 48 / 64

40
OPERATION AND MAINTENANCE SCHEDULE FOR
MODELS S130 AND S260
INTERVAL ITEM PROCEDURE
As Needed Ash removal Remove ash and observe condition of ash.
Adjust grate timer if necessary.
Weekly Fire bed (when
burning poor
quality coal) Check for clinkers and remove if necessary.
Note: poor coal quality produces clinkers.
Every 3 months Roller chains Lubricate with chain oil and take up slack.
Every 3 months Drive belt Check belt condition. Replace or adjust tension.
Every 3 months Pitman shaft Lubricate brass bushings with a few drops of oil.
Every 3 months Fan shaft
bearings(belt drive
models only)
Grease with high temperature grease.
Every 6 months Abrasion shield Check for leakage around gasket. Adjust or
replace if necessary.
Every 6 months Flue pipe Check for leakage around seams and re-seal if
necessary
End of season Cam bearing on
grate Check to make sure bearings are free to rotate.
End of season Fire box Clean and inspect fire box
End of season Swirl chamber Clean and inspect
Inspect fan condition
End of season Ceramic heat
shield Check for wear around fan shaft hole – replace if
gap is greater than 1/6”
End of season Flue pipe Remove flue tube assembly and clean
Inspect cyclone funnel