D000449-00 Rev. A
41
Enclosure Reattachment
1.
A cylindrical plastic rod is sewn in the bottom of the
enclosure and fits in the small groove between the
outer edge of the wood and the inside of the metal
base.
Attach the back of the enclosure in the groove first,
and then attach the sides.
2.
Place the bottom edge of the metal slats on the
enclosure side of the plastic rods located in the hem
of the enclosure.
The rod should be trapped between the slat and the
outer frame.
Set the plastic sliders on the slat with the tapered end
of each slider facing the metal tab. The slat will be
angled toward the enclosure.
Using your hands, push down on the metal slat
(pushing on the plastic sliders will be more
comfortable) to clear the metal tabs, then rotate the
top edge of the slat outwards, capturing the slat under
the metal tabs.
In the illustration, the plastic sliders have been
attached and the slat is ready to be pushed down and
rotated into place.
When you place a slat, ensure that it is centered
properly with regard to the metal tabs, as shown in the
illustration. This is the rear slat, and it has an equal
overhang on each end tab.
