IS0133 Rev B 11/14/19
Altelix LLC USA: 866-660-WIFI (9434) International: +1 561-660-9434 [email protected] www.altelix.com
Copyright (C) 2019 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See
www.altelix.com
for most current information
Page-4
NP141105/NP171406 DIN Enclosure Guide
WARNING:
INSTALLATION OF THIS PRODUCT NEAR POWERLINES IS
DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS
Under some conditions, this enclosure may not prevent electrocution. Users should keep
enclosure away from any overhead wires. If enclosure contacts a power line, any initial
protection could fail at any time. IF ENCLOSURE NEARS ANY OVERHEAD WIRES,
IMMEDIATELY LET GO, STAY AWAY, AND CALL UTILITY COMPANY
THIS ENCLOSURE IS DESIGNED TO BE INSTALLED ONLY BY A TRAINED PROFESSIONAL
INSTALLER
Warning:
To avoid electric shock, grounding must be installed by the installer as part of the
installation. The unit must be grounded and installed in accordance with National Electrical
Codes (NEC) and any local codes. Note that non-metallic enclosures do not provide
grounding between conduit connections.
Warning:
Enclosure must be secured using a pad-lock when energized to prevent
unauthorized access and shock hazard.
Important:
Look over the site before beginning installation, and anticipate possible hazards.
Select a safe site to install the enclosure.
If you have power lines in the area, call your local electric utility for assistance.
NEVER
work alone; always have someone near who can summon help.
Check weather conditions. Be sure that the area is not slippery and make sure that rain or
thunderstorms are not predicted for the day you install the enclosure.
If you need to use a ladder, make sure it is made of non-conductive (non-metallic) material
.
Enclosures improperly installed or installed to an inadequate structure are susceptible to
wind damage that can be very serious or even life threatening. Ensure that the installation is
properly grounded. Ensure that the enclosure is properly secured and structurally sound to
support all loads (weight, wind & ice).
Rooftop Installation Warning
DO NOT
assume that just because you're on a roof, you're isolated from ground. You may
still be electrocuted or fall off the roof.
Got Questions?
We are here to help.
Contact us at:
USA & Canada: 866-660-9434
International: +1 561-660-9434
When mounting, ensure the rubber bonded washers completely cover the
enclosure mounting holes to provide a water-tight seal. Silicone sealant
can also be added to enhance the seal.
Wall Mounting
Mounting Hole Dimensions
NP141105-DIN
NP171406-DIN
Note:
Drilling Templates can be download by visiting www.ALTELIX.com in the
Resources section.
Shown with Equipment Mounting Plate Removed for Clarity
