Page-2
Wall Mounting
Page-3
NP171406-DIN Shown
1. Using a ¼” drill bit, drill two
holes into the rear of the
enclosure at the locations shown.
The NP141105-DIN and NP171406-DIN enclosures can be wall mounted using
the supplied hardware or pole mounted using the optional
NMK Series
pole
mounting kits available from www.ALTELIX.com.
2. Drill wall as required. See
mounting hole dimensions on
page 3.
Included with the enclosure are
(4) Rubber Bonded Washers and
(4) Screws with Wall Anchors.
Drill Locations
Top of Enclosure
3. Place Rubber Bonded
Washers onto the Screws
as shown.
4. Secure the enclosure to wall using the (4) screws in locations shown.
NP141105-DIN Shown
1. Install the Equipment Mounting Plate into the enclosure as shown
using the supplied (4) self-tapping screws.
2. Install the DIN rails onto the equipment mounting plate as shown
using supplied #8-32 screws and washers. Threaded holes are
provided in the plate for mounting.
Installing Equipment Mounting Plate & DIN Rails
Equipment Mounting Plate
DIN Rails
Additional DIN Rails for both the NP141105-DIN and NP171406-DIN are
available from www.ALTELIX.com
(Note: Installing additional DIN Rails will require mounting holes to be drilled in the
equipment mounting plate)
