Altec ISA-Slot, Руководство пользователя

Страница: 5 / 12

5
Manual Version 1.2 PCBoardCard: ISA-Slot PC Card Drive
2.1.3 Configuration with the altec BIOS Setup program
-
If the BIOS extension is enabled, the following message should appear during the POST
(Power On Self Test) of the PC:
“altec PCBoardCard BIOS Ver “ “press <ALT-S> for setup”
If setup is required, press ALT-S to access the altec Setup program in the altec ROM-
BIOS (Note! the time available to press the key combination can be very short on fast
PC’s). You should then see the configuration screen of the altec Setup program. The
configuration screen is subdivided into three sections and allows a variety of
configuration settings to be made.
The current entry field is highlighted. The following key allocation is used within the altec
Setup program:
Cursor Up -> go to next entry field
Cursor Down -> go to previous entry field
ESC -> exit altec Setup program, changes are not stored
F10 -> store changes (after a prompt) and
exit altec Setup program
F6 -> set all entry fields to their default value
SPACE -> change the value in the currently-active entry field
After exiting the Setup program, the PC is rebooted automatically in order to activate the
changes you have made. The entry fields have the following significance:
A) Section “General Configuration”
- Display ALT-S Message
Possible values are ENABLED and DISABLED. If you choose ENABLED, the message
“Press
<ALT-S>...” is displayed at boot time during BIOS installation. If DISABLED,
the altec Setup program can still be called with ALT-S although the message is not
shown.
- Halt if Error
Possible values are ENABLED and DISABLED. If you choose ENABLED, the message “
Press any key to continue” is displayed at boot time during BIOS installation if the
PCMCIA controller cannot be found.
- PCMCIA CHIP Base Address
This field is for information only and cannot be changed.
B) Section “Slot 1 (upper) Configuration”
This section is used to configure the upper PCMCIA slot.
- Disk Emulation
This field specifies which physical drive should be emulated by this slot. Possible values
are DISABLED, A: B: C: D: and Append.
Please note the following:
.