Altec ATP-4310, Руководство пользователя

Страница: 44 / 89

- 37 -
If the wrinkle on the label starts from the
lower left side to upper right side, please do
following adjustment.
1. Clockwise direction adjust the ribbon
tension adjustment knob to “2” or “1”
position. Then check if wrinkle is gone.
2. Decrease the right side print head
pressure adjustment knob setting 1 level
per each adjustment then print the label
again to check if wrinkle is gone.
3. If the right side print head adjustment
knob setting has been set to index 1 (the
lowest pressure index), please increase
the left side print head pressure.
4. If the left side print head adjustment knob
setting has been set to 5 (the highest
pressure index) the wrinkle can’t be
avoid, please rotate the both knobs back
to setting 1 then rotate the Z-axis
mechanism adjustment knob clockwise
for a few degrees and print again for fine
tune the print head pressure distribution.
Note for step 4:
*Factory default setting, the Z-axis knob is
rotated counter clockwise to the end of
thread.
*Turn the Z-axis mechanism adjustment
knob clockwise until you feel the knob
touch the mechanism for the first
adjustment.
* If the wrinkle is still there, please turn the
Z-axis mechanism adjustment knob
clockwise about 1/4 circle each time for
adjustment
* If the winkled direction is change from “/”
to “\” by adjusting the Z-axis mechanism
adjustment knob, please turn the Z axis
mechanism adjustment knob counter
clockwise to avoid the wrinkle.
If the wrinkle on the label starts from the
lower right side to upper left side, please do
following adjustment.
1. Counter clockwise adjust the ribbon
tension adjustment knob to “4” or “5”
position. Then check if wrinkle is gone.
2. Decrease the left side print head
pressure adjustment knob setting 1 level
per each adjustment then print the label
again to check if wrinkle is gone.
3. If the left side print head adjustment
knob level has been set to index 1 (the
lowest index), please increase the right
side print head pressure.