4
Getting Started
how to Install the Ac Adapter
1
Connect the AC adapter cable plug
into the speaker system’s jack.
The jack is located on the back of the
system.
2
Plug the AC adapter into the wall
outlet.
how to charge the Lithium-Ion battery
Your Altec Lansing inMotion Max speaker
system includes a rechargeable lithium-ion
battery. This battery should be fully charged
before initial use of the speaker system. A full charge will provide up to 3.5
hours of continuous playing time.
When the battery icon on the LCD screen displays a single segment, you
should recharge the battery. When the battery icon starts flashing, the
speaker system is about to automatically shut down.
1
Connect the speaker system to a wall outlet.
See the
How to Install the AC Adapter
section. The battery icon on
the LCD screen will show the battery is charging.
2
Allow the battery to charge.
Charging time: Up to 3 hours for a full charge. When the battery is
fully recharged, the battery icon is shown as full.
WARNING
During the recharging process, it is typical for the battery
to become warm. To be safe, keep flammable materials away from the
speaker system.
how to Disconnect the Rechargeable battery
If you need to replace the lithium-ion battery, you will need to first remove it.
1
Unplug the speaker system from the wall outlet.
2
Remove the rechargeable battery compartment cover.
The battery compartment is located on the back of the speaker
system. Remove the 2 screws securing the cover in place. Then
remove the cover.
3
Unplug the battery and remove it.
NOTe
The lithium-ion battery must be properly recycled or disposed of.
Please contact your local recycling center for proper battery handling and
disposal instructions.
how to Install the enhanced Remote battery
The enhanced remote battery (included) is not installed at the factory. To
install the battery, follow the steps below:
1
Pull out the battery holder.
The battery door is located on the
lower end of the remote. Simply pull
the tab to open the battery holder.
2
Position the battery (included) so it
sits in the battery holder correctly.
Make sure the polarity (the + and – sides of the battery) is correct.
3
Replace the battery door.
NOTe
Please discard used batteries properly.
