4 | Operation
BYK-Gardner GmbH
24
wave-scan 3 ROBOTIC
301 200 141 E 2010
4.4 Productive System
The instrument is designed to measure in full automatic mode. Only re-
quirement is to configure the instrument(s) and the data output inter-
face(s) in
smart-robotic
. After are successful testing the configuration can
be copied from the test system to the productive system and adapted.
Illustration 22:
Robot cell with two robots / Robot arm with two instruments
When the robotic instruments are configured and mounted, the measure-
ments will be done automatically by the robot according to the program-
ming in the PLC.
Illustration 23:
Monitoring tab in smart-robotic
Only raw data will be measured – no processing and evaluation takes place.
This allows very fast measurements by the robot. To store the measurement
results:
• If
smart-chart
is used, the measurement results will be written into
smart-chart
database – according to existing configuration of color
standards and check-zone organizers.
• If
smart-chart
is not used, the measurement results will be written to
files on disk for external processing and evaluation.
For more details on operation in the productive environment see Operating
Instructions for
smart-robotic
.
