PLACING AN EQUALIZER CARD:
Before placing the equalizer card you should adjust it, for this it is recommended that
read the previous sections carefully, if you haven't done yet.
In order to place an equalizer card in the main board, follow the next steps:
Turn off the crossover and disconnect it of the mains.
Remove the connector jumper where you want to insert the equalizer card (the connec-
tors where you could insert the equalizer card are indicated in a table on page 24).
Insert the equalizer card in the connector, guiding the printed circuit board toward the
component overlay indication of the card orientation in the main board. Take care to insert
the connector carefully, and don't move it forward, behind, left or right. All the main board
male conector contacts should join in the female equalizer card connector.
WARNING: Before carrying out any operation inside the crossover, disconnect it of the
mains.Upon being connected to the mains, the crossover contains elements with high
tensions, and if for a negligence you touch one of those parts could cause a short circuit
through your body with the rising danger for your health.
CAUTION: Do not insert an equalizer card with the crossover turn on, this could cause its
break.
CAUTION: After placing the equalizer card in a insert connector, and before turning on the
crossover, make sure that the equalizer card is placed correctly in the main board connector,
and that any of the connector contacts is out of it. A wrong placement of the equalizer card,
could cause that the crossover and the equalizer card break.
29
1
2
3
