6
3. WORKING PRECAUTIONS
The manufacturer is not responsible of any damage that can possibly happen to the
intercom desk station outside the limits of the warranty or those produced by not taking care of
the working precautions.
The intercom line DC voltage must be between the limits of the admitted power supply
(12-32 VDC). Damage caused by a connection to an improper line DC voltage is not covered by
any warranty.
DANGER:
Inside the unit there are components at high temperature. Do not open it. The unit
does not contain elements that could be repaired by the user. Whenever the intercom master
station is connected to the intercom lines, it carries elements with moderate voltages. In order to
disconnect the unit completely, you must disconnect it from the intercom lines.
CAUTION
:
Protect the unit from the rain and moisture. Ensure that no objects or liquids enter it.
If liquid is spilled into the unit, disconnect the intercom system from the line and consult a
qualified service technician.
Do not place the unit close to heat sources.
4. INSTALLATION
4.1. UNPACKING
Before leaving the factory, each intercom desk station has been carefully inspected and
tested. You can unpack and inspect the unit for any damage that may have occurred during
shipment. If any damage is found, does not connect the unit to the mains; notify the salesperson
immediately; a qualified service technician should inspect the unit.
Save the original packing, you could use if you need to transport the unit.
NEVER SHIP THE
INTERCOM DESK STATION WITHOUT ITS ORIGINAL PACKING.
4.2. MOUNTING
The ALTAIR ES-203 CL desk station is designed to be mounted in different ways
depending on the application environment. The rear connectors pcb can be mounted on the rear
or in the upper side to facilitate connection.
DESK STATION
It is possible to mount either directly over the desk using the four
enclosed adhesive feet or by using the two including lateral brackets in
any angle position.
The brackets permits choosing different angle position of the desk
station and can be installed with the screw holes inside/outside. It permits
screw it to the mounting surface for extra stability.
CONNECTOR PANEL
- Normally mounted on the upper side.
WALL MOUNT
You can mount it into the wall by using the lateral brackets as depicted above or by
boxing it directly over the wall with appropriate tools and accessories.
ES-203 CL DUAL CHANNEL DESK STATION
