TPS13-001_rev1_4_A8n_series_Installation_Guide_for_FCC.doc
Commercially Confidential
25
2.
Start wrapping a layer of butyl rubber tape 1” (25mm) below the electrical tape. Overlap the
tape to half –width. Finish the wrap at the base of the antenna port and cut the tape. Take
extra care to make sure that the RF cable connector to A8n series 5GHz antenna RF port
junction is tightly sealed. Press the tape edges together so that there are no gaps. Press the
tape against the RF cable connector body and the A8n series 5GHz antenna RF port.
3.
Start wrapping a layer of electrical tape 1” (25mm) below the butyl rubber tape, overlapping
at half-width. Finish the wrap at the base of the A8n series 5GHz antenna RF port and cut
the tape. Repeat this process for a second layer, and if enhanced UV protection is required, a
third layer.
