Altai Technologies Ltd. All rights reserved
A8n Series Super WiFi Base Station Installation Guide
TPS13-002_rev1.0
2.
Start wrapping a layer of butyl rubber tape from the base of the A8n series 5GHz
antenna port. Overlap the tape to half –width. Finish the wrap at 1” (25mm)
above the electrical tape and cut the tape. Take extra care to make sure that
the RF cable connector to A8n series 5GHz antenna port junction is tightly sealed.
Press the tape edges together so that there are no gaps. Press the tape against
the RF cable connector body and the A8n series 5GHz antenna port.
3.
If enhanced UV protection is required, start wrapping a layer of electrical tape
from the base of the A8n 2.4GHz antenna port. Overlap the tape to half –width.
Finish the wrap at 1” (25mm) above the butyl rubber tape and cut the tape.
6.4.
Weatherproofing A8n series 5GHz Antenna RF Ports
1.
Start wrapping a layer of electrical tape from 1/4” (6mm) above the edge of the
RF cable connector. Overlap the tape to half –width. The tape should cover the
RF cable connector body, and extend 1” (25mm) above the cable connector
clamping nut.
The tape can be applied in one or more strips if necessary. A strip can be coiled
onto an applicator such as a pencil. Apply only enough tension to get good
adhesion and keep the tape smooth.
2.
Start wrapping a layer of butyl rubber tape 1” (25mm) below the electrical tape.
Overlap the tape to half –width. Finish the wrap at the base of the antenna port
and cut the tape. Take extra care to make sure that the RF cable connector to
A8n series 5GHz antenna RF port junction is tightly sealed. Press the tape edges
together so that there are no gaps. Press the tape against the RF cable
connector body and the A8n series 5GHz antenna RF port.
Extend 1”
(25mm)
Figure 6-5 Wrapping direction and extends the wrap 1” above the connector clamping
