ALS Brake Wired Install Guide
4
© Alsense Motorsport SRL
3.
Physical Installation
Before installing the sensor in its final position, please ensure that:
1.
All the necessary configuration parameters have been set (number of channels and order,
emissivity, startup delay time). We can perform these for you if you get in touch with us
before shipping or using the ‘Notes’ field in the checkout process.
2.
There are provisions for installing the required 120 Ω CAN bus termination resistors. Pleas
e
see section ‘
3. Electrical Installation
’ for further details
The sensor should be mounted in its final position using the mounting holes situated on the sides
of the housing. For temporary installs we’ve successfully used 3M Dual-Lock tape, but extra care
should be employed when using such a solution.
