01. Only install on a suitable base (e.g. aluminium) to ensure sufficient heat transfer to
the environment.
Attention: When mounting on an electrical conductive base, an additional,
overlapping insulation (adhesive foil) is required.
02. Can be cut to length ...
03. ... only at marked points.
04. Power supply 24V DC
red = plus (+) / black = ground (-). Do not wire the wrong way! Connect the module
only with a suitable LED-power supply 24V DC constand voltage and enough power.
05. A feed line can be soldered to the
remainder module.
06a.
Segments can be connected
by soldering of abridge. Solder up the upper soldering point (pict. 06b) with the lower point (pict. 06c).
Soldering points become visible as soon as protection foil is taken off.
Don’t take off the foil completely
as not to lose the adhesive
power of FLEXY.
Attention!
Maximum 5m of Flex strip can be installed with one feeder. For more, additional feeding is required.
Attention! When mounting on an electrical conductive base, an additional, overlapping insulation (adhesive foil) is required.
07. Minimum radius of bending 3 cm.
08. Do not bend, bending will damage the
conductors.
FLEXY
2
6
00
0
8
07
06c
06b
06a
05
schwarz /
black
rot /
red
0
4
03
02
01
