OTHER
Troubleshooting
Are you misunders-
tanding, miss-usage
as system malfunction?
Are installation and
wiring correctly
completed?
Please check the
list below again.
If the problem is still
exists,please contact your
nearest dealer.
•
If you encounter a problem such as sudden
system shut down or the screen becomes
dimmed, please turn the power off, then on
again. If the unit is still not functioning normally,
please review the items in the following
checklist. This guide will help you isolate
the problem.
Not functioning.
•
Vehicle ignition is off or the key position is not
at ACC position.
·
Start the engine or turn the key to ACC position.
•
No fuse or blown fuse.
·
Install fuse or check the cause of the blown fuse
before replacing.
•
Improper connection.
·
Please recheck the connection.
•
Vehicle’s battery is weak.
·
Please check the voltage of the battery.
No picture or unclear picture.
Picture color is poor.
•
Brightness/Color/Tint/Contrast/Sharpness
control are not set to the proper positions.
·
Check each control.
Picture’s movement is bad.
•
Temperature in the cabin is too high.
·
Please allow some time for the temperature
becomes normal operating temperature.
Spots or dotted lines/stripes appear.
•
Caused by neon signs, high-voltage power lines,
CB transmitter, other vehicle’s ignition plugs, etc.
·
Change the location of your vehicle.
Optional Wireless Remote Control does
not work.
•
The LCD panel is manufactured
using an extremely high precision
manufacturing technology. Its effective
pixel ratio is over 99.99%. This
means that 0.01% of the pixels
could be either always ON or OFF
20
•
Brightness control is set for minimum brightness
control.
·
Adjust the brightness.
•
Incorrect setting of the mode.
·
Switch to the correct mode.
·
Check the connection to the source unit.
·
Check the power of the source unit.
•
Incorrect or open connection with the Monitor,
AV interface unit.
·
Check the connection and remedy.
•
There are something obstruct communication
between the Remote Control and the Receiver.
·
Please remove the object.
•
The polarities of the battery in the Remote
Control are wrong.
·
Please re-insert the battery.
•
The battery’s life.
·
Please replace with new battery.
