FR
ES
DE
SE
IT
5
-EN
Turning Power On or Off
1
Press the PWR (Power) button to turn on the unit.
The opening screen appears automatically.
2
Press the PWR (Power) button again to turn off
the unit.
NOTES
• The TME-M790 draws minimal current even
when its power switch is turned off. If the
switched power (ignition) lead of the TME-
M790 is connected directly to the positive (+)
post of the vehicle's battery, the battery may be
discharged. If this lead is unswitched, it must
be disconnected from the battery post should
the vehicle be left unused for an extended
period of time.
An SPST (Single-Pole, Single-Throw) switch (sold
separately) can be added to simplify this procedure.
Then, you can simply place it in the OFF position
when you leave the vehicle. Turn the SPST switch
back ON before using the TME-M790. For
connecting the SPST switch, refer to the Installation.
• Some operation of the unit cannot be performed
while the vehicle is in motion. In this case, be sure to
first stop your vehicle and apply the parking brake,
then perform the operation.
• After turning the system off, a slight ghost of the
image will remain temporarily. This is an effect
peculiar to LCD technology and is normal.
• Under cold temperature conditions, the screen may
lose contrast temporarily. After a short warm-up
period, it will return to normal.
Selecting the Monitor Opening
Angle
The monitor opening angle can be set in 2
positions.
1
Press and hold the OPEN/CLOSE button for at
least 2 seconds while the monitor is being
raised. Each press changes the monitor angle
back or forth.
NOTE
When the OPEN/CLOSE button is pressed and held for
at least 2 seconds when the neck angle is adjusted, the
neck angle adjustment is canceled.
After doing this, adjust the display in the front/rear
direction.
Adjusting the Monitor Viewing
Angle
Adjust the monitor's angle for better visibility.
1
While viewing the screen that is shown press the
9
or
8
button to adjust the display to the ideal
viewing angle.
The display viewing angle can be adjusted
between 40 and 105 degrees.
2
Press the
4
or
3
button to adjust the right-left
viewing angle. It is possible to adjust the display
viewing angle up to 15 degrees to the left or
right.
Press and hold the OPEN/CLOSE button for at
least 2 seconds to cancel the neck angle
adjustment.
NOTES
• The angle changes continuously if the
9
and
8
buttons or the
4
and
3
buttons are held down.
• If there are any obstructions to the monitor
when adjusting the angle, first remove the
obstruction and then readjust the angle.
• The screen color will vary when viewed at certain
angles. Adjust the screen angle for the best viewing
position.
• If the voltage of the vehicle's battery power is
low, the screen may blink when the screen angle is
changed. This is normal and not a malfunction.
• The adjusted angle is stored in the memory.
Adjusting the Volume
1
Press the
or
button to adjust the volume.
NOTE
The volume changes continuously if the
or
button is held down.
Switching the Source
1
Press the AUX button. Each press of the button
will cycle through the modes as follows:
NAVIGATION
AUX1
AUX2
