Jeep Wrangler
WRANGLER
z
13/19
Amplifier Installation
1
Use a 10mm socket to connect the power cable
to the POSITIVE (+) battery terminal. Note: The
NEGATIVE terminal should remain disconnected
until the installation is completed.
3
Route the power cable along the vehicle’s frame
following the OEM harness towards the back
until reaching the rubber grommet under of the
passenger side seat.
View from passenger underside of vehicle
5
Route and secure the power cable along the factory
harness using the supplied cable ties as shown
below.
View from cabin. Passenger seat area.
2
Route the power cable following the OEM harness
as shown below.
4
Route the cable through the rubber grommet and
seal with silicone. (silicone not supplied)
6
Using a 10mm socket attach the (black) NEGATIVE
(-) ground cable to the factory ground point under
the seat.
View from inside cabin. Passenger side
seat area.