Jeep Wrangler
WRANGLER
z
12/19
1
Position the seat in a secure manner to gain access
to the bottom of the seat.
3
On the left seat bracket, use a 9/32” drill bit to
enlarge the two outer mounting holes of the OEM
harness mounting plate.
5
Secure the connector plugs using cable ties to the
left side of the seat as shown below.
2
Using a T30 Torx, remove the OEM harness
mounting plate as shown below. Use a panel
removal tool to remove the two plugs from the
mounting plate.
4
Use a #2 Phillips screw driver to attach the
mounting brackets to the subwoofer with the M4
screws.
6
Attach the subwoofer to the seat using the M6
screws. Do not tighten until the seat is inside the
vehicle and the amplifier mount is attached.
Subwoofer Installation