29
-EN
01GB05IVA100R.fm
ALPINE IVA-D100R 68-05946Z50-A (EN)
Blackout Mode On and Off
When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.
1
Press
VISUAL
on the unit.
The VISUAL selection screen is displayed.
2
Touch
[
]
of OFF.
The backlit-display portion goes out.
The guide indicator blinks slowly.
3
Touch
[
]
of OFF again to cancel the display
backlight.
•
To apply the setting, set to VISUAL in “Setting the VISUAL Button”
(page 37).
•
If any button on the unit is pressed during Blackout mode, the
function will be displayed for 5 seconds to show the operation before
returning to Blackout mode.
Setting rear Camera Interruption
When the rear camera is connected, rear pictures are output on the
screen.
1
Select CAMERA in “Setting the AUX Mode”
(page 37).
2
Press VISUAL on the unit.
The VISUAL selection screen is displayed.
3
Touch
[
]
of CAMERA.
Rear picture is output even if you do not engage the shift
lever in reverse (R).
4
To cancel the setting, press VISUAL on the unit, and
touch
[
]
of NORMAL.
•
By shifting to reverse (R),the rear pictures are output. This function is
effective when the reverse wire is properly connected.
Monitor Setting Operation
1
Press
SETUP
.
The SETUP selection screen is displayed.
2
Touch
[
]
of MONITOR.
The MONITOR screen appears.
3
Touch
[
]
or
[
]
of the desired item to change its
setting.
Setting items:
TILT / SLIDE / OPEN / CLOSE
4
Touch
[RTN]
to return to the previous screen.
Adjust the monitor's angle (between 40 and 105 degrees) for optimum
visibility.
Setting item: TILT
Setting range: 10 adjustable angles are available.
•
If the monitor touches an obstacle, remove the obstacle.
•
The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
•
If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is not a malfunction.
The monitor can be set in 2 positions.
Setting item: SLIDE
Setting content: BACK / FRONT
•
If the monitor is forcibly pushed or pulled, you may not be able to set
the monitor angle or position. In this case, press OPEN for more than
2 seconds to close the monitor once, and then open the monitor
again.
Setting item: OPEN / CLOSE
Setting content: MANUAL / FULL / CLOSE
Monitor Setting
Following Steps 1 to 4 describe the common procedures for
operating the MONITOR setting function. For details of the
setting function items, refer to descriptions of respective items.
Adjusting the Monitor Angle
Selecting the Monitor Position
BACK:
Slides the display backwards.
FRONT:
Slides the display forwards.
Setting Automatic Opening/Closing of the
Monitor
MANUAL:
The monitor is manually opened or closed by
pressing
OPEN
.
FULL:
The monitor automatically opens or closes when the
ignition key is turned to the “ACC” or “ON/OFF”
position.
CLOSE:
The monitor automatically closes when the ignition
key is turned OFF.
01GB00IVAD100R.book Page 29 Friday, February 10, 2006 2:39 PM
