27
-EN
Installation
1
Uninstall the car stereo with its mounting bracket.
2
Remove the cables and the mounting bracket
attached to the car stereo.
(The mounting bracket will be used in “Installing the unit”.)
For safe use, make sure of the following:
•
Location is stable and firm.
•
Driver’s view and operations are not obstructed.
•
Microphone is located where the driver’s voice can be easily
picked up (for example, on the sun visor).
When you speak into the microphone, you should not have to
change your driving posture. This may cause a distraction,
taking your attention away from safely driving your vehicle.
Carefully consider direction and distance while mounting the
microphone. Confirm that the driver’s voice can be easily picked
up at the selected location.
1
Remove the Face Plate from the unit.
2
Mount the original mounting bracket to the unit
using the supplied screws.
3
Connect all other leads of the unit according to
details described in the “Connections” section
(page 29).
4
Mounting the unit in a car.
*
1
To securely connect the ground lead, use an already installed screw
on a metal part of the vehicle (marked (
)) or a clean, bare metal
spot on the vehicle’s chassis.
*
2
Use the removed Face Plate if needed.
Fix the cables carefully. Do not damage them by tucking them
into movable parts, such as a seat rail, or by locating them
against sharp or pointed edges.
Uninstalling the original car stereo
Mounting the Microphone.
Note on installation
•
Install at an angle between horizontal and 30°. Note that
installing at an angle outside of this range will result in a
loss of performance and possible damage.
Rear of the Unit
0 - 30°
•
Do not block the unit’s heat sink, which would prevent air
circulation. If blocked, heat will accumulate inside the
unit and may cause a fire.
Heat sink
Rear of the Unit
Installing the Unit
Fix the Cables etc.
Microphone
Cable clamp
(Sold separately)
Original Mounting Bracket
Screws (M5 x 8)
(Included)
Face Plate (Included)
*
2
Ground Lead
*
1
Chassis
