19
-EN
3
Touch the desired application.
•
“Auxiliary (AUX)” can be selected while in AUX mode.
•
The camera names set under the “Camera” settings are
displayed. The camera names are not displayed when “Off” is
set (page 22).
4
Touch
[ ]
of the desired item.
Settable items differ depending on the application.
[Auxiliary (AUX)]:
Display Mode / Brightness / Color / Contrast / Sharpness
[Camera]:
Brightness / Color / Contrast
5
Touch
[
]
or
[
]
to change its setting.
6
Touch
[
]
to return to the main application screen.
Touch
[ ]
to return to the previous screen.
•
Immediately after changing the settings of Display Setup (While the
system is writing data automatically) do not turn the ignition key to
OFF. Otherwise, the settings may not be changed.
Setting item: Display Mode
Setting contents: WIDE (Initial setting) / NORMAL
In WIDE mode, the picture is stretched horizontally to fill the
entire display.
In NORMAL mode, the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
Setting item: Brightness
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the brightness between MIN (-15) and MAX
(+15). When it reaches the minimum or maximum point, the
display shows “MIN” or “MAX” respectively.
Setting item: Color
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the Color between MIN (-15) and MAX (+15).
When it reaches the minimum or maximum point, the display
shows “MIN” or “MAX” respectively.
Setting item: Contrast
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the contrast between MIN (-15) and MAX (+15).
When it reaches the minimum or maximum point, the display
shows “MIN” or “MAX” respectively.
Setting item: Sharpness
Setting content: -3 to +3 (Initial setting: 0)
Picture quality adjustment range is -3 to +3. “SOFT” and “HARD”
appear as the minimum and maximum values.
When adjusting Camera, you can store the settings made for “Adjusting
Brightness, Color, and Contrast”.
Setting item: Preset1 / Preset2
1 After completing “Adjusting Brightness, Color, and
Contrast” (page 19), touch and hold
[Preset1]
or
[Preset2]
to save the settings.
2 Touch
[Preset1]
or
[Preset2]
to call the saved settings.
General Setup Operation
Switching Display Modes
Adjusting Brightness
Adjusting Color of Picture
Adjusting Image Contrast
Adjusting Picture Quality
Saving and calling the adjusted picture
quality
General Setup
To display the General Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
•
For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General Setup Menu, as long as the car’s ignition has not been
turned off. It is not necessary to repeat the above procedure
(1 through 2) of “To display the General mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the General mode screen.”
The following steps 1 to 4 are common operations to each
“Setting item” of General Setup. Refer to each section for
details.
