51
-EN
Installation and Connections
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10 cm away from the car harness.
•
Keep the battery power leads as far away from other leads as possible.
•
Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•
If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further information.
•
Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Foot Brake Lead/Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
NOTES
•
If your vehicle has no ACC power supply, add an
SPST (Single-Pole, Single-Throw) switch (sold
separately) and fuse (sold separately).
•
The diagram and the fuse amperage shown above are
in the case when CVA-1014 is used individually.
•
If the switched power (ignition) lead of the CVA-1014
is connected directly to the positive (+) post of the
vehicle‘s battery, the CVA-1014 draws some current
(several hundred milliamperes) even when its switch is
placed in the OFF position and the battery may be
discharged.
1
Vehicle Cable
Stopper
Monitor Cable
Pinch Connector
2
Pliers
CVA-1014
Chassis
(Yellow/Black)
(Yellow/Blue)
Foot brake lamp
Foot brake lead
Parking brake lamp
Parking brake lead
Pinch Connector
Pinch Connector
Foot brake switch
Parking brake switch
Battery
FOOT BRAKE
PARKING BRAKE
CVA-1014
Battery
(Red)
SPST SW (Optional)
(Yellow)
BATTERY
IGNITION
FUSE (5A)
(optional)
FUSE (10A) (optional)
