6
-EN
Accessory List
•
Head unit ............................................................................1
•
Power cable ........................................................................1
•
FULL SPEED
TM
Connection Cable
(CDE-9882Ri only)..............................................................1
•
Mounting sleeve.................................................................1
•
Carrying case .....................................................................1
•
Rubber Cap ........................................................................1
•
Hex Bolt ..............................................................................1
•
Screw (M5 × 8)....................................................................4
•
Owner’s Manual .......................................................... 1 set
Turning Power On and Off
Press
SOURCE/
to turn on the unit.
•
The unit can be turned on by pressing any other button except
(OPEN).
Press and hold
SOURCE/
for at least 2 seconds to
turn off the unit.
•
The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press
(OPEN)
to open the front panel.
To close the front panel, press the left side until it locks as
shown in the figure below.
3
Grasp the front panel firmly, slide to the left
, and
then pull
to remove.
•
The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
•
To protect the front panel, place it in the supplied carrying case.
•
When detaching the front panel, do not apply excessive force as it
may result in malfunction.
•
Do not leave the front panel open, or drive the car with the panel
open as it may result in an accident or malfunction.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
•
Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
•
Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
SOURCE/
Rotary encoder
(OPEN) MUTE
Содержание CDE-9880R
Страница 2: ......
